CLA-2-28:OT:RR:NC:N3:136
Brett Harris
Roll & Harris LLP
2001 L Street, NW, Suite 500
Washington, DC 20036
RE: The tariff classification and country of origin of Helium in Non-Refillable Tanks from various countries
Dear Mr. Harris:
In your letter dated February 19, 2025, on behalf of your client, Unique Industries, Inc., you requested a tariff
classification and country of origin determination ruling.
In your submission, you state that the imported products will be produced under one of the following five
scenarios:
1. Helium produced in Canada, Poland, Australia, Algeria, Qatar, or South Africa will be shipped to China.
In China, the helium will be filled into non-reusable Chinese origin steel cylinders. The filled tank will be
packaged for retail sale and exported to the U.S.
2. Helium produced in Canada, Poland, Australia, Algeria, Qatar, or South Africa will be shipped to Vietnam,
Malaysia, Thailand, or Indonesia. In these countries, the helium will be filled into non-reusable Chinese
origin steel cylinders. The filled tank will be packaged for retail sale and exported to the U.S.
3. Chinese origin non-reusable cylinders will be exported to countries where helium is produced - e.g.,
Canada, Poland, Australia, Algeria, Qatar or South Africa. In these countries, the helium gas will be filled
into non-reusable Chinese origin steel cylinders. The filled tank will be packaged for retail sale and exported
to the U.S.
4. Helium produced in the United States will be shipped to China. In China, the helium will be filled into
non-reusable Chinese origin steel cylinders. The filled tank will be packaged for retail sale and exported to
the U.S.
5. Helium produced in the United States will be shipped to Vietnam, Malaysia, Thailand, or Indonesia. In
these countries, the helium will be filled into non-reusable Chinese origin steel cylinders. The filled tank will
be packaged for retail sale and exported to the U.S.
You describe the production process as follows:
While helium is in a gaseous state under normal temperature and atmospheric pressure conditions, in each of
the above scenarios the bulk helium transported to the listed countries will be a mixture of liquid helium and
gaseous helium in a vacuum, heat-insulating, low temperature (approximately -268.9) pressure vessel. Upon
receipt at the local factories, the bulk mixture of helium will be distributed from this original pressure vessel
to other, smaller pressure vessels under normal temperature and lower pressure conditions. This distribution
process will cause the liquid helium in the mixture to be converted to a gaseous state.
To prepare the helium for retail sale, the non-refillable steel tank is first filled with local origin atmospheric
air at a pressure of approximately 0.2-0.3 Megapascals (MPa). Helium gas (with a purity greater than
99.99%) from one of the listed countries – prepared from the bulk mixture as described above – is then added
to the tank until the pressure reaches 3.1 MPa. After cooling, the finished product contains approximately
85% helium/15% air at a pressure of approximately 2.8 MPa and a standard room temperature of 20. The
helium in each tank will be sourced from a single country of origin and will not be commingled with helium
from other countries.
Helium will comprise more than 50% of the total expected average cost of the imported product in each of
the scenarios listed above (and may reach up to 55% of the total cost). The remainder of the cost is expected
to include the cost of the non-refillable steel cylinder (including valve), retail packaging, labor (for the filling
operations), transportation costs for the cylinders (where filled in a country other than China), profit and
overhead. The cost of the non-refillable steel cylinder is expected to comprise no more than 30%-35% of the
total cost of the imported product in each scenario.
Classification under the Harmonized Tariff Schedule of the United States (HTSUS) is made in accordance
with the General Rules of Interpretation (GRIs). GRI 5(b) states that, “Subject to the provisions of rule 5(a)
above, packing materials and packing containers entered with the goods therein shall be classified with the
goods if they are of a kind normally used for packing such goods. However, this provision is not binding
when such packing materials or packing containers are clearly suitable for repetitive use. The instant steel
tanks are of a kind normally used for packing helium gas and are not refillable. In accordance with GRI 5(b),
the steel tanks are packaging classifiable with the imported helium.
For the five above-described scenarios, the applicable subheading for Helium in Non-Refillable Tanks will be
2804.29.0010, HTSUS, which provides for Hydrogen, rare gases, and other nonmetals: Rare gases: Other:
Helium. The general rate of duty will be 3.7 percent ad valorem.
Products of Canada as provided by heading 9903.01.10 in Section XXII, Chapter 99, Subchapter III, U.S.
Note 2(j), HTSUS, other than products classifiable under headings 9903.01.11, 9903.01.12, 9903.01.13,
9903.01.14, and 9903.01.15, HTSUS, will be subject to an additional 25 percent ad valorem rate of duty. At
the time of entry, you must report the applicable Chapter 99 heading, i.e. 9903.01.10, in addition to
subheading 2804.29.0010, HTSUS, listed above. Articles that are entered free of duty under the terms of
general note 11 to the HTSUS (U.S.-Mexico-Canada Agreement (USMCA)), including any treatment set
forth in subchapter XXIII of Chapter 98 and subchapter XXII of chapter 99 of the HTSUS, will not be
subject to the additional ad valorem duties provided for in heading 9903.01.10. If your product is entered
duty free as originating under the USMCA, you must report heading 9903.01.14, HTSUS, in addition to
subheading 2804.29.0010.
In scenarios four and five, the imported Helium in Non-Refillable Tanks containing U.S. origin helium may
be entitled to duty-free entry under subheading 9801.00.10, HTSUS. Subheading 9801.00.10 provides for
duty-free entry of U.S. products that are exported and returned without having been advanced in value or
improved in condition by any means while abroad. Articles satisfying these conditions are afforded duty-free
treatment provided the documentary requirements of 19 C.F.R. §10.1 are met. We believe that the addition of
foreign atmospheric air and repackaging of the U.S. origin helium does not preclude classification under
subheading 9801.00.10, HTSUS.
Duty rates are provided for your convenience and are subject to change. The text of the most recent HTSUS
and the accompanying duty rates are provided at https://hts.usitc.gov/.
In your request, you also inquired about country of origin. When determining the country of origin, the
substantial transformation analysis is applicable. See, e.g., Headquarters Ruling Letter (“HQ”) H301619,
dated November 6, 2018. The test for determining whether a substantial transformation will occur is whether
an article emerges from a process with a new name, character, or use different from that possessed by the
article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This
determination is based on the totality of the evidence. See National Hand Tool Corp. v. United States, 16
C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
We agree that the mixing of helium gas with atmospheric air and the filling of the cylinders does not
constitute a substantial transformation of the helium. The country of origin of the imported Helium in
Non-Refillable Tanks, described in the five above scenarios, is determined by the origin of the helium.
The holding set forth above applies only to the specific factual situation and merchandise description as
identified in the ruling request. This position is clearly set forth in Title 19, Code of Federal Regulations
(CFR), Section 177.9(b)(1). This section states that a ruling letter is issued on the assumption that all of the
information furnished in the ruling letter, whether directly, by reference, or by implication, is accurate and
complete in every material respect. In the event that the facts are modified in any way, or if the goods do not
conform to these facts at time of importation, you should bring this to the attention of U.S. Customs and
Border Protection (CBP) and submit a request for a new ruling in accordance with 19 CFR 177.2.
Additionally, we note that the material facts described in the foregoing ruling may be subject to periodic
verification by CBP.
This ruling is being issued under the provisions of Part 177 of the Customs and Border Protection
Regulations (19 C.F.R. 177).
A copy of the ruling or the control number indicated above should be provided with the entry documents
filed at the time this merchandise is imported. If you have any questions regarding the ruling, please contact
National Import Specialist Nuccio Fera at [email protected].
Sincerely,
(for)
Steven A. Mack
Director
National Commodity Specialist Division