CLA-2-72:S:N:N1:117 879033
Mr. Vincent Bowen
Willkie Farr & Gallagher
Three Lafayette Centre
1155 21st Street, NW
Washington, D.C. 20036-3384
RE: The tariff classification of steel plates from Brazil.
Dear Mr. Bowen:
In your letter dated October 2, 1992 on behalf of Primary
Steel, Inc., you requested a tariff classification ruling.
The products to be imported are nonalloy steel plates for
railway or liquid propane gas (LPG) tanks. The plates will be
made to ASTM Specification A516, Grade 70. ASTM Spec A516 is the
Standard Specification for Pressure Vessel Plates, Carbon Steel,
for Moderate-and Lower-Temperature Service. The rectangular
plates which will be used to make the tank bodies will be
imported in various sizes; the following are some typical
dimensions: 0.4375" x 85.875" x 348.75" and 0.728" x 135.312" x
373.50". Flat steel circles to make the tank heads will also be
imported. The steel circles range from 0.450" to 0.780" in
thickness and from 135.3125" to 147" in diameter. The steel
circles are torch cut from hot-rolled plate. The steel plates
for the tank bodies are hot-rolled, cut to the required
dimensions, bevelled and, in some cases, perforated.
Each shipment of steel plates will consist of the necessary
number of circular and rectangular steel plates to make several
tank assemblies. After importation, the steel plates will be
segregated for distribution to various U.S. tank assemblers. The
processing after importation consists of flanging and forming the
steel circles into dish shapes and laterally bending and welding
the tank body plates into rings. The fabricated tank cylinders
will then be welded to the fabricated tank heads.
The applicable subheading for the hot-rolled carbon steel
circles, the hot-rolled bevelled carbon steel plates and the hot-
rolled perforated carbon steel plates will be 7208.90.00,
Harmonized Tariff Schedule of the United States (HTS), which
provides for flat-rolled products of iron or nonalloy steel, of a
width of 600 mm or more, hot-rolled, not clad, plated or coated,
other. The rate of duty will be 5 percent ad valorem.
You suggest in your ruling request that these hot-rolled
plates should be classified as unfinished tanks in accordance
with GRI 2(a). Explanatory Notes 2(a)(V) and (VII) provide some
guidance on the application of GRI 2(a) to products such as those
that Primary Steel, Inc. is planning to import. The
classification of unfinished and unassembled goods is addressed
at some length in a ruling request you initiated, HQ ruling
081999 dated
December 10, 1990.
This ruling is being issued under the provisions of Section
177 of the Customs Regulations (19 C.F.R. 177).
A copy of this ruling letter should be attached to the entry
documents filed at the time this merchandise is imported. If the
documents have been filed without a copy, this ruling should be
brought to the attention of the Customs officer handling the
transaction.
Sincerely,
Jean F. Maguire
Area Director
New York Seaport